Page 1 of 1

EMON II Settings Questions

PostPosted: Fri Nov 04, 2011 9:56 am
by dvkall
I've just installed some Deka Gells and am resetting my EMON. I don't know what Full V setting to use. I have the SARV 3 and while it has the set points for the Gells I don't see any voltage numbers that I can transfer over to the EMON.

So under the Menu Program/B1 Full V What voltage will I put in there?

Also I don't know where or how do I get the Effic setting?

The batteries are 4 DEKA Gel 8G30H.

I see in your article http://www.amplepower.com/gel/index.html you used a voltage of 14.4 and wondering if that is correct for me? Seems higher then the AGM's I replaced.

Thanks for your help.

Re: EMON II Settings Questions

PostPosted: Fri Nov 04, 2011 2:31 pm
by Coulomb
Set Full V to 14.00. Set Full A to 16.0 Set efficiency to 92%, and after a few cycles with at least one of them below 50% capacity, it will auto correct.