Use 100 A - 50 mV shunt for Aux Channel on EMON II

For the Energy Monitor, ESP, and other monitors

Use 100 A - 50 mV shunt for Aux Channel on EMON II

Postby Geof on Fri May 09, 2014 12:29 pm

Hello,

I did not see in the installer manual how to offset for a 100 A @ 50 mV shunt for the AUX channel in the EMON II. I see that it must be Calibrated. How is this done?

thank you.
Geof
 
Posts: 1
Joined: Wed Apr 30, 2014 12:01 pm

Re: Use 100 A - 50 mV shunt for Aux Channel on EMON II

Postby Coulomb on Sat May 10, 2014 3:45 pm

Unless you have a calibrated current source the only way is to set the calibration constant for full scale appropriately.

See what is is set for 400 Amp shunt and set it to 1/4.
Coulomb
Site Admin
 
Posts: 1174
Joined: Sat Jun 06, 2009 5:11 pm


Return to Ample Power Monitors

Who is online

Users browsing this forum: No registered users and 1 guest

cron