Page 1 of 1

Use 100 A - 50 mV shunt for Aux Channel on EMON II

PostPosted: Fri May 09, 2014 12:29 pm
by Geof
Hello,

I did not see in the installer manual how to offset for a 100 A @ 50 mV shunt for the AUX channel in the EMON II. I see that it must be Calibrated. How is this done?

thank you.

Re: Use 100 A - 50 mV shunt for Aux Channel on EMON II

PostPosted: Sat May 10, 2014 3:45 pm
by Coulomb
Unless you have a calibrated current source the only way is to set the calibration constant for full scale appropriately.

See what is is set for 400 Amp shunt and set it to 1/4.