ESAHM #2001

For the Energy Monitor, ESP, and other monitors

ESAHM #2001

Postby RJB on Tue May 13, 2014 8:16 pm

Dear Service consultant:

I have been in contact with Mitch Ishihara in 2007 regarding no reading for Main Alternator. The ESHAM was sent to you for repair but your service section said it checked out OK. The issue must be with the Alternator Current Sensor (ACS)
I do not get an output voltage from the ACS but have mv input from shunt to the ACS. I would like to send the ACS for repair/replacement. Is this possible for such an old unit?

However first is there a way I can input a voltage to the ALT channel of the ESHAM to insure that the unit is functioning properly

How can I arrange to have the ACS repaired or replaced.

Robert J Burns
Townsville, Australia
Posts: 1
Joined: Tue May 13, 2014 12:26 pm

Re: ESAHM #2001

Postby Coulomb on Tue May 13, 2014 9:22 pm

The ESAHM and Alternator Current Sensor were last manufactured in the early 1990s.

Sorry, but we don't have a way to test them or fix them.
Site Admin
Posts: 1174
Joined: Sat Jun 06, 2009 5:11 pm

Return to Ample Power Monitors

Who is online

Users browsing this forum: No registered users and 1 guest