Page 1 of 1

ESAHM #2001

PostPosted: Tue May 13, 2014 8:16 pm
by RJB
Dear Service consultant:

I have been in contact with Mitch Ishihara in 2007 regarding no reading for Main Alternator. The ESHAM was sent to you for repair but your service section said it checked out OK. The issue must be with the Alternator Current Sensor (ACS)
I do not get an output voltage from the ACS but have mv input from shunt to the ACS. I would like to send the ACS for repair/replacement. Is this possible for such an old unit?

However first is there a way I can input a voltage to the ALT channel of the ESHAM to insure that the unit is functioning properly

How can I arrange to have the ACS repaired or replaced.

Regards;
Robert J Burns
Townsville, Australia

Re: ESAHM #2001

PostPosted: Tue May 13, 2014 9:22 pm
by Coulomb
The ESAHM and Alternator Current Sensor were last manufactured in the early 1990s.

Sorry, but we don't have a way to test them or fix them.