Proper Settings For Emon II

For the Energy Monitor, ESP, and other monitors

Proper Settings For Emon II

Postby Johnny7 on Mon Jul 27, 2015 6:56 pm

I just replaced my house batteries. 2 Lifeline GPL-8DA. Each has the following ratings:
20 hr rate 255
bulk charge 14.2 to 14.6
absorb 14.2 to 14.6
float 13.10 to 13.4
Charge amp up to 637.5

What are all the proper settings to program EMON II?

I'm not an electrician but can certainly input proper values into system. I don't want to undo wiring to check values like the manual says to do for voltage calibration and current calibration but will if I have to.

When plugged into shore power the batteries charge to 100%.
When running off of alternator batteries charge very slowly. Motor sailed 5 hours and only showed an increase of 1.6 percent from 76.4 to 77%.

Please help. Thank you.
Johnny7
 
Posts: 1
Joined: Mon Jul 27, 2015 4:37 pm

Return to Ample Power Monitors

Who is online

Users browsing this forum: No registered users and 1 guest

cron