calibrate bat 2?

For the Energy Monitor, ESP, and other monitors

calibrate bat 2?

Postby Single on Wed Oct 19, 2016 3:39 pm

been trying to read battery voltage on a new 12 volt battery for starting. i have checked the voltage on the wire to TB1# 3 terminal and it reads proper. I believe I did exactly what the manual said to not do by holding the button and lost control of the number of pushes. i did a factory reset and that did not solve the issue. what else can I do?

Thanks all
Single
 
Posts: 5
Joined: Wed Oct 19, 2016 1:29 pm

Re: calibrate bat 2?

Postby Coulomb on Thu Oct 20, 2016 1:04 pm

What is the model number?
Coulomb
Site Admin
 
Posts: 1174
Joined: Sat Jun 06, 2009 5:11 pm

Re: calibrate bat 2?

Postby Single on Thu Oct 20, 2016 4:27 pm

going back to the boat tomorrow, will find out. it is a older model i am sure, purchased from jack rabbit marine maybe 15 years ago, has been working fine
Single
 
Posts: 5
Joined: Wed Oct 19, 2016 1:29 pm

Re: calibrate bat 2?

Postby Single on Fri Oct 21, 2016 2:19 pm

it is a EMON 11 H2 a from early 1990s
Single
 
Posts: 5
Joined: Wed Oct 19, 2016 1:29 pm

Re: calibrate bat 2?

Postby Coulomb on Fri Oct 21, 2016 3:18 pm

There are manuals from this here: http://www.amplepower.com/wire/index.html

I wouldn't be able to provide much help beyond that.
Coulomb
Site Admin
 
Posts: 1174
Joined: Sat Jun 06, 2009 5:11 pm

Re: calibrate bat 2?

Postby Single on Sun Oct 23, 2016 3:37 pm

ok.i will just call it a lost cause, I do have a backup monitor for the start battery
Single
 
Posts: 5
Joined: Wed Oct 19, 2016 1:29 pm


Return to Ample Power Monitors

Who is online

Users browsing this forum: No registered users and 1 guest

cron