Page 1 of 1

calibrate bat 2?

PostPosted: Wed Oct 19, 2016 3:39 pm
by Single
been trying to read battery voltage on a new 12 volt battery for starting. i have checked the voltage on the wire to TB1# 3 terminal and it reads proper. I believe I did exactly what the manual said to not do by holding the button and lost control of the number of pushes. i did a factory reset and that did not solve the issue. what else can I do?

Thanks all

Re: calibrate bat 2?

PostPosted: Thu Oct 20, 2016 1:04 pm
by Coulomb
What is the model number?

Re: calibrate bat 2?

PostPosted: Thu Oct 20, 2016 4:27 pm
by Single
going back to the boat tomorrow, will find out. it is a older model i am sure, purchased from jack rabbit marine maybe 15 years ago, has been working fine

Re: calibrate bat 2?

PostPosted: Fri Oct 21, 2016 2:19 pm
by Single
it is a EMON 11 H2 a from early 1990s

Re: calibrate bat 2?

PostPosted: Fri Oct 21, 2016 3:18 pm
by Coulomb
There are manuals from this here: http://www.amplepower.com/wire/index.html

I wouldn't be able to provide much help beyond that.

Re: calibrate bat 2?

PostPosted: Sun Oct 23, 2016 3:37 pm
by Single
ok.i will just call it a lost cause, I do have a backup monitor for the start battery