AutoSwitch...Smart Charging Solenoid

This forum is for general electrical issues. See other forums for product specific issues

AutoSwitch...Smart Charging Solenoid

Postby BarbRick on Thu Jun 26, 2014 5:19 am

Device is not functioning.
This device serves a 12 volt house bank and a 12 volt engine start bank. House bank is seeing the charger output voltage, but start bank does not.
Solenoid does not "click".
AutoSwitch Controller is showing a flashing red light (~1 sec on/off Interval) and Flashing green light (same interval).

Need more ideas to diagnose cause of problem.

Rick
Rick
BarbRick
 
Posts: 4
Joined: Thu Jun 26, 2014 1:17 am

Re: AutoSwitch...Smart Charging Solenoid

Postby Coulomb on Thu Jun 26, 2014 11:14 am

The manual indicates that error is caused by both the Open and Close inputs are activated.
Coulomb
Site Admin
 
Posts: 1174
Joined: Sat Jun 06, 2009 5:11 pm

Re: AutoSwitch...Smart Charging Solenoid

Postby BarbRick on Fri Jun 27, 2014 5:18 am

Does this mean that theOptional S1 SPDT switch is defective?
Rick
BarbRick
 
Posts: 4
Joined: Thu Jun 26, 2014 1:17 am

Re: AutoSwitch...Smart Charging Solenoid

Postby Coulomb on Fri Jun 27, 2014 11:39 am

Measure the voltage on the pins to find out.
Coulomb
Site Admin
 
Posts: 1174
Joined: Sat Jun 06, 2009 5:11 pm


Return to General Electrical

Who is online

Users browsing this forum: No registered users and 2 guests

cron