Page 1 of 1

AutoSwitch...Smart Charging Solenoid

PostPosted: Thu Jun 26, 2014 5:19 am
by BarbRick
Device is not functioning.
This device serves a 12 volt house bank and a 12 volt engine start bank. House bank is seeing the charger output voltage, but start bank does not.
Solenoid does not "click".
AutoSwitch Controller is showing a flashing red light (~1 sec on/off Interval) and Flashing green light (same interval).

Need more ideas to diagnose cause of problem.

Rick

Re: AutoSwitch...Smart Charging Solenoid

PostPosted: Thu Jun 26, 2014 11:14 am
by Coulomb
The manual indicates that error is caused by both the Open and Close inputs are activated.

Re: AutoSwitch...Smart Charging Solenoid

PostPosted: Fri Jun 27, 2014 5:18 am
by BarbRick
Does this mean that theOptional S1 SPDT switch is defective?

Re: AutoSwitch...Smart Charging Solenoid

PostPosted: Fri Jun 27, 2014 11:39 am
by Coulomb
Measure the voltage on the pins to find out.