Page 1 of 1

Interstate SRM 4D Deep Cycle Flooded setting

PostPosted: Tue Sep 14, 2010 5:03 pm
by BillC808
What is the recommended SAR V3 Battery Type Setting for 3 - Interstate SRM 4D deep cycle flooded batteries?

Also, do I press the top of the dip in for ON?

Re: Interstate SRM 4D Deep Cycle Flooded setting

PostPosted: Tue Sep 14, 2010 9:27 pm
by Coulomb
Medium plate, liquid electrolyte.

Usually the switches have an 'On' engraved to show the ON position.

Re: Interstate SRM 4D Deep Cycle Flooded setting

PostPosted: Wed Sep 15, 2010 9:14 am
by BillC808
Thank you for the battery setting.

The dip switches are the "rocker" type. If the rocker is in the DOWN position on the side of the switch engraved with "ON", then is that dip switch set to ON?

Also, Interstate recommends against equalization for these batteries. Should I remove the P1 jumper?

Re: Interstate SRM 4D Deep Cycle Flooded setting

PostPosted: Wed Sep 15, 2010 1:57 pm
by Coulomb
Switch depressed on the ON side is on.

Equalization won't happen unless you activate it from the terminal block.