smart alternator regulator v3

For all issues involving the Smart Alternator Regulators, V1, V2 and V3

smart alternator regulator v3

Postby bobjan on Sun Feb 12, 2012 12:22 pm

this continues previous post on feb. 11

I have operated the above system for a numnber of years, and have very few problems, all of which were soved by tracking down the negative side of the system. Recently I had to repolace the old gear (transmission) in the vessel. The engine had to be realligned about 3/4 inch higher. In the process, all the negative wiring and about half of the positive wiring was disconnected. Since then the regulator will shut down entirely for no apparent reason. Sometimes, say 15 minutes after starting the engine, and sometimes it will drive the alternator for hours and then shut down. I would appreciate any comments from whomever has had any of the same problems.

ps: What should dip switches 1, 2, and 3 be set on if I am using west marine agm batteries?
Posts: 3
Joined: Sat Feb 04, 2012 3:53 pm

Re: smart alternator regulator v3

Postby Coulomb on Sun Feb 12, 2012 5:15 pm

It's most likely a corroded connection that sometimes opens up.

Remove the in-line fuses and clean them with alcohol.

Set dip switches for Concorde AGM.
Site Admin
Posts: 1174
Joined: Sat Jun 06, 2009 5:11 pm

Return to Smart Alternator Regulators

Who is online

Users browsing this forum: No registered users and 2 guests