Missing Part? SAR V3

For all issues involving the Smart Alternator Regulators, V1, V2 and V3

Missing Part? SAR V3

Postby jeide on Thu May 31, 2012 4:55 am

I recently cleaned up the installation of the Smart Alternator Regulator - V3 and discovered a small, about 1/8 x 1/4 x 3/8", black plastic block, brass contacts inside, lying under the SAR V3. It seems to be able to slip over the posts or terminals marked P1 and P3 on the circuit board, which are both bare at this point.
My questions are: does this block belong on one or the other of terminals P1 or P3 (which?) and/or should there be a second small plastic block to fit over the other terminal?
Thanks for your help.
John
jeide
 
Posts: 2
Joined: Thu May 31, 2012 12:12 am

Re: Missing Part? SAR V3

Postby Coulomb on Thu May 31, 2012 10:48 am

Those are jumpers which are used to activate current limiting and equalization. More information is in the manual.
Coulomb
Site Admin
 
Posts: 1174
Joined: Sat Jun 06, 2009 5:11 pm

Re: Missing Part? SAR V3

Postby jeide on Thu May 31, 2012 11:14 am

Thanks for your quick response.
So there should be a jumper on both P1 and P3, correct?
Thanks,
John
jeide
 
Posts: 2
Joined: Thu May 31, 2012 12:12 am

Re: Missing Part? SAR V3

Postby Coulomb on Fri Jun 01, 2012 3:01 pm

Please read about jumper usage the manual.
Coulomb
Site Admin
 
Posts: 1174
Joined: Sat Jun 06, 2009 5:11 pm


Return to Smart Alternator Regulators

Who is online

Users browsing this forum: No registered users and 1 guest

cron