Page 1 of 1

Remote Error Warning LED and Beeper

PostPosted: Tue Jun 02, 2015 10:26 pm
by jgd
I am planning to wire a remote LED (for 12 volt, with resistor) and Beeper (purchased from Ample Power) to my recently purchased NS2 Regulator. Is there any special connection required for the beeper, or does it just wire in parallel with the LED, connected to TB2 - #2?

Re: Remote Error Warning LED and Beeper

PostPosted: Wed Jun 03, 2015 12:00 am
by Coulomb
Yes, positive on the beeper to TB2-2 and negative on the beeper to ground.