Regulator control in gas charge mode

For all issues involving the Smart Alternator Regulators, V1, V2 and V3

Regulator control in gas charge mode

Postby grgaz on Mon Dec 05, 2016 11:20 am

I have a 900AH (lifeline)house bank being charge controlled by a V3 and DAC. Dixie DelStar Alternator output rated at 200A each(assuming correct rpm and temp).

Testing new installation : Batteries at 62% capacity, 23.8 to 24v and house draw at 75A.
Started engines at 650rpm and noted regulator indicated "Gas Charge" mode.
Alternators providing sufficient current to cover house (75A) and an additional 103A charge current. Total of 178A output.
Increased the RPM to 1250 and the charge current remained around 107A even though the alternators are easily capable of supplying 175A each at this rpm.

Is this result to be expected, ie. is the charge current limited to approx 107A based on the battery/regulator parameters, or is there something else going on?

If it is regulator/DAC controlled, is the charge current shared by both alternators?
grgaz
 
Posts: 7
Joined: Fri Sep 30, 2016 5:52 pm

Re: Regulator control in gas charge mode

Postby Coulomb on Mon Dec 05, 2016 2:00 pm

What's going on is the regulator is working. At the time you saw it the state was at gassing voltage. Just because the alternators are capable of more, the batteries will only accept what they will at any particular voltage.

Alternators in a dual situation produce at their capabilities given RPM and applied field voltage. They may not share equally in current.
Coulomb
Site Admin
 
Posts: 1174
Joined: Sat Jun 06, 2009 5:11 pm


Return to Smart Alternator Regulators

Who is online

Users browsing this forum: No registered users and 1 guest

cron