Page 1 of 1

New Install

PostPosted: Mon Sep 07, 2009 11:36 am
by Jimmy
I understandthe function of the SIGNAL NAMED PARALLEL. In my install I did not connect a wire to the parallel post, so why is thw parallel light on the cover on?
I have read the manuel and examined your drawings and cannot find the answer to this question. After spending $1000 with your compay I would appreciate and answer other than read the manuel.

Re: New Install

PostPosted: Tue Sep 08, 2009 10:40 am
by Coulomb
The output signal is driven whether or not anything is connected to the connector. The LED is connected to that signal, and just indicates that the signal is active.