Page 1 of 1

SARV3 batt volt sense location

PostPosted: Tue Dec 01, 2009 3:09 pm
by atmarineserv
Hi Coulomb,
just verifying the location of the volt sense and temp sense on the house bank. This is a 3 battery house bank, AGM, in paralell, 315AH, 12V. I am going to install the temp sensor, on the battery that is connected to the hot buss / positive distrubution, and then then the battery V sense to the battery "farthest" from the battery that is connected to the hot buss. Sound Good? Thanks,Zach

Re: SARV3 batt volt sense location

PostPosted: Tue Dec 01, 2009 3:37 pm
by atmarineserv
Should be under SAR,sorry!

Re: SARV3 batt volt sense location

PostPosted: Tue Dec 01, 2009 3:42 pm
by Coulomb
If the batteries are wired in parallel correctly, then the location isn't too critical. If not, put the sensor on the positive post closest to the positive distribution point.