Page 1 of 1

SAR V3-12P

PostPosted: Wed Jan 15, 2014 8:21 am
by AlanD
As you have not fully answered my post of 15th December, here it is again:
I have a SAR V3-12P charging a bank of Trojan T105 batteries. Trojan recommend these are charged at 14.5 volts at 30 degrees centigrade (temperature corrected). The SAR is only putting out 14.2. Can this be adjusted? The battery type selector switch S1 is set to thick plate liquid.

Re: SAR V3-12P

PostPosted: Thu Jan 16, 2014 10:11 pm
by Coulomb
Without a temp. sensor connected to the regulator, you should see about 14.4 Volts.

You can add series resistance in the B1V Sense lead. It affects the output voltage about 1/2 Volts per 1000 Ohms.

Re: SAR V3-12P

PostPosted: Fri Jan 17, 2014 11:15 am
by AlanD
Thank you.