Page 1 of 1

NS2 Field Voltage

PostPosted: Sat May 14, 2011 12:39 pm
by dennisgade
I am on my second NS2 regulator. It has been working fine until today. All inputs to the regulator are correct. The field voltage does not turn on. This is similar to another problems that I had an returned for it for replacement. In both cases, the field voltage didn't work after I had pulled out my batteries for maintenance. I operator that answered the phone at Ample power said I needed to reset unit without giving me details. Is there a reset process for me to follow to correct problem or is the unit defective and if so, why does this occur after pulling batteries? I checked the on/off voltage from the switch and it reads as it should as well as all of the other readings on TB1

Thank you

Dennis Gade

Re: NS2 Field Voltage

PostPosted: Wed May 18, 2011 4:43 pm
by Coulomb
The tech just finished checking the regulator that you returned. No problem found.

It sounds like an intermittent wiring problem.