Page 1 of 1

No Parallel Singal

PostPosted: Sat Jun 22, 2013 8:29 am
by Curtis
My Next Step 2 is not raising signal on the parallel pin (pin 1, TB2). The parallel LED illuminates, and the unit is otherwise working fine, but no voltage output is measured at the pin.

Tested with multimeter between pin 1 and battery negative.

Further troubleshooting suggestions?

Re: No Parallel Singal

PostPosted: Sun Jun 23, 2013 11:53 am
by Coulomb
The PCB trace must be open between the LED and the terminal block. Maximum current draw for the output is 0.5 Amps.

Re: No Parallel Singal

PostPosted: Sun Jun 23, 2013 4:11 pm
by Curtis
Thanks. Will have to unmount regulator to get a closer look to confirm.