Battery Volts disconnect error code on first install

For issues involving the NS2 regulator.

Battery Volts disconnect error code on first install

Postby Kevin on Tue Jan 07, 2014 9:28 am

Just installed NS2 replacing Next Step. On installing, the red led is flashing 3 seconds on 1 second off indicating battery volts input is disconnected. I checked the 3 amp fuse and when I disconnect the fuse, the red led quit flashing. Reconnected and after a few seconds the red error code led started flashing again indicating a disconnect on the battery volts circuit. What is going on? Circuit shows battery volts to the unit.
Kevin
 
Posts: 2
Joined: Mon Dec 23, 2013 12:08 pm

Re: Battery Volts disconnect error code on first install

Postby Coulomb on Tue Jan 07, 2014 6:53 pm

What's the green light doing?

Did you note the difference in error, status and parallel solenoid wiring between the Next Step and the NS2?
Coulomb
Site Admin
 
Posts: 1174
Joined: Sat Jun 06, 2009 5:11 pm

Re: Battery Volts disconnect error code on first install

Postby Kevin on Wed Jan 08, 2014 9:13 am

I think the problem is resolved. The first time I applied power from the ignition switch, the red light when out. When I disconnected the NS2 plug and re plugged it in, the red light flashed until I applied ignition power the first time then it went out. The green light was flashing the code that the on off power was off 3 sec on, 3 seconds off.
Kevin
 
Posts: 2
Joined: Mon Dec 23, 2013 12:08 pm

Re: Battery Volts disconnect error code on first install

Postby Coulomb on Tue Jan 14, 2014 3:50 pm

Thanks for the update.
Coulomb
Site Admin
 
Posts: 1174
Joined: Sat Jun 06, 2009 5:11 pm


Return to NS2 Regulators

Who is online

Users browsing this forum: No registered users and 1 guest

cron