Page 1 of 1

Battery Volts disconnect error code on first install

PostPosted: Tue Jan 07, 2014 9:28 am
by Kevin
Just installed NS2 replacing Next Step. On installing, the red led is flashing 3 seconds on 1 second off indicating battery volts input is disconnected. I checked the 3 amp fuse and when I disconnect the fuse, the red led quit flashing. Reconnected and after a few seconds the red error code led started flashing again indicating a disconnect on the battery volts circuit. What is going on? Circuit shows battery volts to the unit.

Re: Battery Volts disconnect error code on first install

PostPosted: Tue Jan 07, 2014 6:53 pm
by Coulomb
What's the green light doing?

Did you note the difference in error, status and parallel solenoid wiring between the Next Step and the NS2?

Re: Battery Volts disconnect error code on first install

PostPosted: Wed Jan 08, 2014 9:13 am
by Kevin
I think the problem is resolved. The first time I applied power from the ignition switch, the red light when out. When I disconnected the NS2 plug and re plugged it in, the red light flashed until I applied ignition power the first time then it went out. The green light was flashing the code that the on off power was off 3 sec on, 3 seconds off.

Re: Battery Volts disconnect error code on first install

PostPosted: Tue Jan 14, 2014 3:50 pm
by Coulomb
Thanks for the update.