Problem with Bolt in System

For all issue regarding Ample Power Alternators.

Problem with Bolt in System

Postby Sune on Tue May 18, 2010 10:44 pm

I have a problem and I hope you can help me.

I bought a Bolt in system and a 12V alternator # 4059 in 2004.
I installed the Bolt in System and used it as an distribution system.

I didn´t install the alternator at this time, and didn´t use the SAR V3 regulation.

I´am now going to install the alternator and the regulator.

When i look at the installation and operation instruction from you which was delivered with the products (see attached file)
It does not correspond with the product I received, I have taken a Photo of my BIS ( see attached file)

The positive Distribution does not have a Smart Shunt #2
Therefore I don't know where too put your alternator in to the BIS-system, I hope you can tell me.
I also hope you can give me a correct Installation an Operation instructions.
My third question is , why do I have a switch on the right side of the front of the BIS-box. ( see attached file)

I hope for a quick answer because I am leaving Sweden on my sailing boat heading for the Atlantic as soon as possible.
BIS Installation and operation.jpg
BIS Installation and operation.jpg (1.11 MiB) Viewed 1367 times
BIS.jpg
A picture of the inside of the box
BIS.jpg (60.73 KiB) Viewed 1365 times
BIS Box.jpg
The front
BIS Box.jpg (38.17 KiB) Viewed 1364 times


Best regards
Sune Larsson
Stockholm,
Sweden
Sune
 
Posts: 1
Joined: Tue May 18, 2010 12:46 pm

Return to Ample Alternators

Who is online

Users browsing this forum: No registered users and 0 guests

cron