Problem with Bolt in System

For all issue regarding Ample Power Alternators.

Problem with Bolt in System

Postby Sune on Tue May 18, 2010 10:44 pm

I have a problem and I hope you can help me.

I bought a Bolt in system and a 12V alternator # 4059 in 2004.
I installed the Bolt in System and used it as an distribution system.

I didn´t install the alternator at this time, and didn´t use the SAR V3 regulation.

I´am now going to install the alternator and the regulator.

When i look at the installation and operation instruction from you which was delivered with the products (see attached file)
It does not correspond with the product I received, I have taken a Photo of my BIS ( see attached file)

The positive Distribution does not have a Smart Shunt #2
Therefore I don't know where too put your alternator in to the BIS-system, I hope you can tell me.
I also hope you can give me a correct Installation an Operation instructions.
My third question is , why do I have a switch on the right side of the front of the BIS-box. ( see attached file)

I hope for a quick answer because I am leaving Sweden on my sailing boat heading for the Atlantic as soon as possible.
BIS Installation and operation.jpg
BIS Installation and operation.jpg (1.11 MiB) Viewed 1367 times
A picture of the inside of the box
BIS.jpg (60.73 KiB) Viewed 1365 times
BIS Box.jpg
The front
BIS Box.jpg (38.17 KiB) Viewed 1364 times

Best regards
Sune Larsson
Posts: 1
Joined: Tue May 18, 2010 12:46 pm

Return to Ample Alternators

Who is online

Users browsing this forum: No registered users and 1 guest