Page 1 of 1

PSC 12-20amp (if I remember right)

PostPosted: Mon Aug 08, 2011 5:13 pm
by McKee
What does the charge curve look like for these chargers w/o the smart charge regulator?

Re: PSC 12-20amp (if I remember right)

PostPosted: Mon Aug 08, 2011 6:35 pm
by Coulomb
It goes to the setpoint and stays there. You can choose the higher or lower setpoint.

Re: PSC 12-20amp (if I remember right)

PostPosted: Tue Aug 09, 2011 9:14 am
by McKee
Ok... maybe I am asking the wrong question. Roy Meyer helped me design and install this system maybe 7 years ago, and life has kept me from the boat until now, so I am having to start over in a few places.

I am pretty sure (99%) I have one of these (Power Supply/Charger, 15 Amps, 12-Volts #PSC15-12), I will go down to the (long neglected) boat and double check Its stand alone, so not integrated into the EMON, and I have no smart charge manager. Is it acting as a 2 stage charger, 3 stage? Is it even safe to plug into gel batteries? What is the factory set set point? How would I adjust it? Is there a pdf manuel for this charger?

Re: PSC 12-20amp (if I remember right)

PostPosted: Wed Aug 10, 2011 4:54 pm
by Coulomb
As a stand-alone charger, it operates with a bulk cycle followed by a constant voltage, which is high or low depending on the jumper.

It is safe long term for gels on the lower setting.

Re: PSC 12-20amp (if I remember right)

PostPosted: Wed Aug 10, 2011 5:24 pm
by McKee
Thanks, that's what I needed to know.