Page 1 of 1

Installing a New PSC-12

PostPosted: Tue Oct 06, 2009 2:01 pm
by Warren
I receintly received a replacement for my old PSC-12 without instructions. It looks a little different from the PSC-12 it was to replace.

Can it be installed on a partition with the fan on the bottom?

Should the #18 stranded wire from pin 9 on the SCM be supported before attaching to the tinny wire in the plug?

What is meant by "Remove Plug after quick charge"? This makes no sense; for how is the SCM to control the charger if it is not connected to the PSC-12.

Warren

Re: Installing a New PSC-12

PostPosted: Wed Oct 07, 2009 10:18 am
by Coulomb
The units have been shrunk - marching tecnology.

Fan on the bottom is OK.

Yes, support the larger wire.

Ignore the label.