Page 1 of 1

Identification needed

PostPosted: Wed Oct 12, 2011 6:44 pm
by Kristen
Greetings,

I have a 12 - 280 DBC mounted in a sound box in my bus conversion. While doing my weekly inspection I found a bolt and two washers on the floor of the bay. They were in the rear behind the DBC. I cannot see where they fell off, any ideas? See attached photo.

Thanks

Kristen

Re: Identification needed

PostPosted: Thu Oct 13, 2011 10:37 pm
by Coulomb
They don't look like anything used on the DBC.

Re: Identification needed

PostPosted: Thu Oct 27, 2011 1:57 pm
by Kristen
Finally figured out what this is. It is in the back of the large alternator, it appears there are 3 of them. See photos - 1 close up of it reinstalled, and another of the general location showing all three bolts. Thanks for looking.

Re: Identification needed

PostPosted: Thu Oct 27, 2011 1:59 pm
by Kristen
Well, I don't know how you can look at something and it can be right, and then hit submit and it is wrong. Sorry about the general location shot. You'll just have to use your imagination!