Page 1 of 1

Hot Water heat exchanger

PostPosted: Wed Jun 26, 2013 9:26 am
by flem
Can I retrofit my marine application Genie 150 with the "Hot Water Option"?




After shutdown the unit continues to run (loap) and slowly consums the fuel. Trouble shoot?

Re: Hot Water heat exchanger

PostPosted: Wed Jun 26, 2013 11:33 am
by Coulomb
To retrofit for heat recovery, you'll need a pump rated to circulate the coolant, a thermostat so you don't over cool the engine. Then you need to tap the coolant tank for in and out fittings.

The fuel line between the shut off solenoid and the injector pump needs to be as short as possible so there is not much residual fuel left in the hose.

Re: Hot Water heat exchanger

PostPosted: Wed Jun 26, 2013 11:39 am
by flem
Does "Ample Power" still offer a kit for this conversion?

Re: Hot Water heat exchanger

PostPosted: Tue Jul 02, 2013 11:44 am
by Coulomb
No, there wasn't enough demand.

Re: Hot Water heat exchanger

PostPosted: Thu Jul 11, 2013 3:47 pm
by flem
Can you provide a list of Supplier for the for the components and/ or any documentation for the retrofit?

Re: Hot Water heat exchanger

PostPosted: Fri Jul 12, 2013 11:54 am
by Coulomb
Sorry, I don't have that information.