EMON II Settings Questions

For the Energy Monitor, ESP, and other monitors

EMON II Settings Questions

Postby dvkall on Fri Nov 04, 2011 9:56 am

I've just installed some Deka Gells and am resetting my EMON. I don't know what Full V setting to use. I have the SARV 3 and while it has the set points for the Gells I don't see any voltage numbers that I can transfer over to the EMON.

So under the Menu Program/B1 Full V What voltage will I put in there?

Also I don't know where or how do I get the Effic setting?

The batteries are 4 DEKA Gel 8G30H.

I see in your article http://www.amplepower.com/gel/index.html you used a voltage of 14.4 and wondering if that is correct for me? Seems higher then the AGM's I replaced.

Thanks for your help.
Posts: 24
Joined: Wed Aug 19, 2009 6:48 am

Re: EMON II Settings Questions

Postby Coulomb on Fri Nov 04, 2011 2:31 pm

Set Full V to 14.00. Set Full A to 16.0 Set efficiency to 92%, and after a few cycles with at least one of them below 50% capacity, it will auto correct.
Site Admin
Posts: 1174
Joined: Sat Jun 06, 2009 5:11 pm

Return to Ample Power Monitors

Who is online

Users browsing this forum: No registered users and 1 guest