No Parallel Singal

For issues involving the NS2 regulator.

No Parallel Singal

Postby Curtis on Sat Jun 22, 2013 8:29 am

My Next Step 2 is not raising signal on the parallel pin (pin 1, TB2). The parallel LED illuminates, and the unit is otherwise working fine, but no voltage output is measured at the pin.

Tested with multimeter between pin 1 and battery negative.

Further troubleshooting suggestions?
Curtis
 
Posts: 5
Joined: Fri Jun 21, 2013 6:45 pm

Re: No Parallel Singal

Postby Coulomb on Sun Jun 23, 2013 11:53 am

The PCB trace must be open between the LED and the terminal block. Maximum current draw for the output is 0.5 Amps.
Coulomb
Site Admin
 
Posts: 1174
Joined: Sat Jun 06, 2009 5:11 pm

Re: No Parallel Singal

Postby Curtis on Sun Jun 23, 2013 4:11 pm

Thanks. Will have to unmount regulator to get a closer look to confirm.
Curtis
 
Posts: 5
Joined: Fri Jun 21, 2013 6:45 pm


Return to NS2 Regulators

Who is online

Users browsing this forum: No registered users and 0 guests

cron