Remote Error Warning LED and Beeper

For all issues involving the Smart Alternator Regulators, V1, V2 and V3

Remote Error Warning LED and Beeper

Postby jgd on Tue Jun 02, 2015 10:26 pm

I am planning to wire a remote LED (for 12 volt, with resistor) and Beeper (purchased from Ample Power) to my recently purchased NS2 Regulator. Is there any special connection required for the beeper, or does it just wire in parallel with the LED, connected to TB2 - #2?
jgd
 
Posts: 9
Joined: Mon May 11, 2015 4:17 pm

Re: Remote Error Warning LED and Beeper

Postby Coulomb on Wed Jun 03, 2015 12:00 am

Yes, positive on the beeper to TB2-2 and negative on the beeper to ground.
Coulomb
Site Admin
 
Posts: 1174
Joined: Sat Jun 06, 2009 5:11 pm


Return to Smart Alternator Regulators

Who is online

Users browsing this forum: No registered users and 1 guest

cron