Amperage Control

For issues involving the NS2 regulator.

Amperage Control

Postby skins on Sun Apr 04, 2010 12:15 pm

I have an NS2 regulator with a 150 amp alternator on my boat engine.
My battery bank consists of 2 in paralell, 12V AGM Odyssey 2150 batteries of 105 Ahr each.
These batteries can take as much amperage as you can throw at them, up to 3 times the amp hour rating.

How can I control the NS2 reg. to continue with a high amperage charge to top up these batteries in a shorter charge period?

Thanks for any assistance

Terry
skins
 
Posts: 1
Joined: Sun Apr 04, 2010 11:52 am

Re: Amperage Control

Postby Coulomb on Mon Apr 05, 2010 11:46 am

They may take that level of current when deeply discharged, but at the end, they self-limit like every other battery in the world.

Of course you can raise the absorption setpoint until they start blowing out gas from the over pressure vents, but that won't substantially increase the actual rate of absorption within the plates.

Check out the charging recommendations from the manufacturer.
Coulomb
Site Admin
 
Posts: 1174
Joined: Sat Jun 06, 2009 5:11 pm


Return to NS2 Regulators

Who is online

Users browsing this forum: No registered users and 0 guests

cron